2014-12-21 3d printer Bed Auto Levelingを試す:その7 設定がうまく行ったか確かめ。 1. open Pronterface 2. はじめに、位置決め、コマンド。input the command "G28" and send it. 3. つぎは、auto levelingのコマンド、input the command "G29" and send it. これで動作の確認はOK.あとは実際にプリントしてみる。 うまくいかない場合は、 x,Y offsetの向き”+/-”などを確認。 Servoの接続を確認。 いろいろ試すといずれうまくいく。